3D Printing - Support Structures
If a slicer software is set with an overhang angle threshold of 50°, what will happen to model parts with angles of 30°, 45°, and 55° respectively?
If a slicer software is set with an overhang angle threshold of 50°, what will happen to model parts with angles of 30°, 45°, and 55° respectively?
medium📝 Analysis Q5 of 15
Step-by-Step Solution
Solution:
Step 1: Compare each angle to threshold
30° and 45° are less than 50°, so no supports needed; 55° is greater, needs support.Step 2: Determine support placement
Supports are added only where angle exceeds threshold.Final Answer:
Supports added only for 55°, 30° and 45° print fine -> Option DQuick Check:
Supports only if angle > threshold [OK]
Quick Trick: Only angles above threshold get supports [OK]
Common Mistakes:
- Adding supports below threshold
- No supports added at all
Master "Support Structures" in 3D Printing
Want More Practice?
15+ quiz questions · All difficulty levels · Free
Free Signup - Practice All QuestionsMore 3D Printing Quizzes