3D Printing - Advanced Print Settings
If the first layer speed is set to 20 mm/s and the first layer height is 0.2 mm, what is the likely effect on adhesion?
If the first layer speed is set to 20 mm/s and the first layer height is 0.2 mm, what is the likely effect on adhesion?
medium📝 Analysis Q4 of 15
Step-by-Step Solution
Solution:
Step 1: Analyze first layer speed
20 mm/s is a moderate speed that allows filament to stick well without dragging.Step 2: Analyze first layer height
0.2 mm is a common height that provides good bed contact.Final Answer:
Good adhesion due to balanced speed and height -> Option AQuick Check:
Moderate speed + 0.2 mm height = good adhesion [OK]
Quick Trick: Moderate speed and height improve first layer adhesion [OK]
Common Mistakes:
- Assuming any speed above 15 mm/s is bad
- Thinking 0.2 mm height is too thin for adhesion
Master "Advanced Print Settings" in 3D Printing
Want More Practice?
15+ quiz questions · All difficulty levels · Free
Free Signup - Practice All QuestionsMore 3D Printing Quizzes